All-laser-diode high-power RGB light-show system fits in 10-in. cube

Nov. 7, 2014
Laserworld USA (Lake Mary, FL) has unveiled a high-power red-green-blue (RGB) laser light-show system based entirely on the use of laser diodes, which enables the whole system to fit in a space about 10 in. on a side and draw only 300 W of electrical power.

Laserworld USA (Lake Mary, FL) has unveiled a high-power red-green-blue (RGB) laser light-show system based entirely on the use of visible laser diodes, which enables the whole system to fit in a space about 10 in. on a side and draw only 300 W of electrical power. The specified power outputs of the device's lasers are > 2.4 W for red (638 nm), > 3 W for green (520 nm), and > 6 W for blue (450 nm), making the device a CDRH class IV laser. The diode modules were made in Germany.

The system, called PIKO, has a specified output power of 10 W and a typical power of 12 W. Norbert Stangl, sales and marketing director for Laserworld USA, notes that the beam specs of 4 mm diameter and less than 1.0 mrad full-angle output allow the use of small scanner mirrors, reducing scanning inertia and boosting scan rates at scan angles of up to 60°.

The system is sealed within a metal box and weighs 55.1 lb.; a detachable remote-control pad allows the user to stand far from the class IV beam.

The 520 nm green wavelength is close to the peak response wavelength of the human eye. The 638 nm red wavelength is toward the short-wavelength end of the red spectral region, where the eye's response is greater (for red); likewise, the 450 nm blue wavelength is at the long-wavelength edge of the blue spectral region where the eye's blue response is greatest.

For more info, see http://www.laserworld.us/shop/rti-lasers/rti-piko-series/rti-piko-rgb-11-pure-diode

About the Author

John Wallace | Senior Technical Editor (1998-2022)

John Wallace was with Laser Focus World for nearly 25 years, retiring in late June 2022. He obtained a bachelor's degree in mechanical engineering and physics at Rutgers University and a master's in optical engineering at the University of Rochester. Before becoming an editor, John worked as an engineer at RCA, Exxon, Eastman Kodak, and GCA Corporation.

Sponsored Recommendations

How to Tune Servo Systems: Force Control

Oct. 23, 2024
Tuning the servo system to meet or exceed the performance specification can be a troubling task, join our webinar to learn to optimize performance.

Laser Machining: Dynamic Error Reduction via Galvo Compensation

Oct. 23, 2024
A common misconception is that high throughput implies higher speeds, but the real factor that impacts throughput is higher accelerations. Read more here!

Boost Productivity and Process Quality in High-Performance Laser Processing

Oct. 23, 2024
Read a discussion about developments in high-dynamic laser processing that improve process throughput and part quality.

Precision Automation Technologies that Minimize Laser Cut Hypotube Manufacturing Risk

Oct. 23, 2024
In this webinar, you will discover the precision automation technologies essential for manufacturing high-quality laser-cut hypotubes. Learn key processes, techniques, and best...

Voice your opinion!

To join the conversation, and become an exclusive member of Laser Focus World, create an account today!