Tuning fork at room temperature detects terahertz radiation

Sept. 1, 2009
Researchers at the Clausthal University of Technology (Goslar, Germany), the Laboratorio NEST (Pisa, Italy), and the University of Cambridge (Cambridge, England) have created a simple detector for terahertz radiation that works at room temperature.

Researchers at the Clausthal University of Technology (Goslar, Germany), the Laboratorio NEST (Pisa, Italy), and the University of Cambridge (Cambridge, England) have created a simple detector for terahertz radiation that works at room temperature. The device is built around a miniature quartz tuning fork from a standard wristwatch; radiation modulated at the tuning fork’s natural frequency of 32,670 Hz causes the tuning fork to vibrate as a result of radiation pressure (“photon momentum”). The vibration of the tuning fork is sensed by detecting the piezoelectric current produced by the tuning fork as it vibrates.

The detector was tested using a quantum-cascade laser (QCL) as the terahertz source, which emitted on the order of 0.5 mW of 2.8 THz radiation. Because there was some crosstalk between the electronics and the tuning fork, the true reading of the detector was considered to be the measured reading minus a reading taken with all radiation blocked. The photon-momentum detector was tested against a silicon bolometer and a Golay cell, and found to have an approximately linear response over a range of about a factor of five. The detector was also used to capture scanned images. The researchers believe its best use may be as a “monitor photodiode” type detector for a QCL. Contact Ulrike Willer at [email protected].

Sponsored Recommendations

How to Tune Servo Systems: Force Control

Oct. 23, 2024
Tuning the servo system to meet or exceed the performance specification can be a troubling task, join our webinar to learn to optimize performance.

Laser Machining: Dynamic Error Reduction via Galvo Compensation

Oct. 23, 2024
A common misconception is that high throughput implies higher speeds, but the real factor that impacts throughput is higher accelerations. Read more here!

Boost Productivity and Process Quality in High-Performance Laser Processing

Oct. 23, 2024
Read a discussion about developments in high-dynamic laser processing that improve process throughput and part quality.

Precision Automation Technologies that Minimize Laser Cut Hypotube Manufacturing Risk

Oct. 23, 2024
In this webinar, you will discover the precision automation technologies essential for manufacturing high-quality laser-cut hypotubes. Learn key processes, techniques, and best...

Voice your opinion!

To join the conversation, and become an exclusive member of Laser Focus World, create an account today!