Fused-silica cantilevers reveal femtosecond-pulse volume changes

June 4, 2012
Suspecting localized densification coupled to stress accumulation and relaxation in the nanograting regions, Audrey Champoin and Yves Bellouard of the Eindhoven University of Technology have developed an experimental technique to test volume changes in fused silica produced by exposure to femtosecond-laser pulses.

At certain fluences below the ablation threshold, ultrafast-laser pulses produce changes in fused silica including the formation of self-organized patterns consisting of “nanogratings.” Suspecting localized densification coupled to stress accumulation and relaxation in the nanograting regions, Audrey Champoin and Yves Bellouard of the Eindhoven University of Technology (Eindhoven, the Netherlands) have developed an experimental technique to test volume changes in fused silica produced by exposure to femtosecond-laser pulses.

In the technique, a number of fused-silica cantilevers are oriented parallel to each other side by side and fixed at one end to an anchor point. One cantilever is not illuminated and serves as the control; the others are illuminated on one side by scanning the laser beam in a pattern, focusing just below the surface. The result is that any volume changes produced by the laser action cause a beam to deflect through an angle, providing a quantitative measure of local volume change. Light from a laser emitting 380 fs pulses at 1030 nm and an 860 kHz repetition rate was focused through an objective with a 0.40 numerical aperture and scanned across the cantilever surfaces, with the light polarization either transverse or parallel to the scanning direction. The deflections (50 to 90 μm) showed a volume expansion with exposure and a possible weak dependence on polarization; relative estimated expansion was 0.03%. Principal stresses were on the order of 300 MPa. Contact Yves Bellouard at [email protected].

About the Author

John Wallace | Senior Technical Editor (1998-2022)

John Wallace was with Laser Focus World for nearly 25 years, retiring in late June 2022. He obtained a bachelor's degree in mechanical engineering and physics at Rutgers University and a master's in optical engineering at the University of Rochester. Before becoming an editor, John worked as an engineer at RCA, Exxon, Eastman Kodak, and GCA Corporation.

Sponsored Recommendations

Advancing Neuroscience Using High-Precision 3D Printing

March 7, 2025
Learn how Cold Spring Harbor Laboratory Used High-Precision 3D Printing to Advance Neuroscience Research using 3D Printed Optical Drives.

From Prototyping to Production: How High-Precision 3D Printing is Reinventing Electronics Manufacturing

March 7, 2025
Learn how micro 3D printing is enabling miniaturization. As products get smaller the challenge to manufacture small parts increases.

Sputtered Thin-film Coatings

Feb. 27, 2025
Optical thin-film coatings can be deposited by a variety of methods. Learn about 2 traditional methods and a deposition process called sputtering.

What are Notch Filters?

Feb. 27, 2025
Notch filters are ideal for applications that require nearly complete rejection of a laser line while passing as much non-laser light as possible.

Voice your opinion!

To join the conversation, and become an exclusive member of Laser Focus World, create an account today!