Silicon-resonator-stabilized lasers have linewidths of only 0.01 Hz

Aug. 9, 2017
Two independent lasers, each with their own silicon Fabry-Perot cavities and with laser linewidths of just 0.01 Hz, have been created.
1708 Lfw Nb 4 5f4900fb7ae93

Two independent lasers, each with their own silicon Fabry-Perot cavities and with laser linewidths of just 0.01 Hz, have been created by researchers at Physikalisch-Technische Bundesanstalt (PTB; Braunschweig, Germany) and JILA, a joint institute of the National Institute of Standards and Technology and the University of Colorado (Boulder, CO).1 This is a world record, and far smaller than the more-usual kilohertz- or megahertz-scale laser linewidths. The finesse of each Fabry-Perot cavity is close to 500,000. When cooled to 124 K, the commercial erbium-doped distributed feedback (DFB) fiber lasers, when stabilized by the silicon cavities, have a beat note between them of as small as 5 mHz at their 194 THz operating frequency (1542 nm wavelength). The mutual phase coherence times for these two lasers range up to 55 s. The thermal Brownian noise of the cavity mirrors is what limits the linewidth of these lasers from being even narrower.

Since there was no other comparably precise laser in the world, the scientists working on this collaboration had to set up two such laser systems. Only by comparing these two lasers to each other was it possible to prove the outstanding properties of the emitted light. The core piece of each of the lasers is a 21-cm long Fabry-Perot silicon resonator. The two resonator mirrors are kept at a fixed distance using a double silicon cone. Stabilization electronics ensure that the light frequency of the laser constantly follows the natural frequency of the resonator. The new lasers are now being used both at PTB and at JILA to further improve the quality of optical atomic clocks and to carry out new precision measurements on ultracold atoms. At PTB, the ultrastable light from these lasers is already being distributed via optical waveguides and is then used by the optical clocks in Braunschweig. The scientists from this collaboration see further optimization possibilities. With novel crystalline mirror layers and lower temperatures, the disturbing thermal noise can be further reduced. The linewidth could then even become smaller than 1 mHz. Reference: D. G. Matei et al., Phys. Rev. Lett., 118, 2632202 (2017); https://doi.org/10.1103/physrevlett.118.263202.

About the Author

John Wallace | Senior Technical Editor (1998-2022)

John Wallace was with Laser Focus World for nearly 25 years, retiring in late June 2022. He obtained a bachelor's degree in mechanical engineering and physics at Rutgers University and a master's in optical engineering at the University of Rochester. Before becoming an editor, John worked as an engineer at RCA, Exxon, Eastman Kodak, and GCA Corporation.

Sponsored Recommendations

Working with Optical Density

Feb. 26, 2025
Optical Density, or OD, is a convenient tool used to describe the transmission of light through a highly blocking optical filter.

Custom-Engineered Optical Solutions for Your Application

Feb. 26, 2025
Explore the newest and most widely used applications of Semrock optical filters.

Linear Stages & Rotary Stages for High Precision Automation & Motion Control

Feb. 13, 2025
Motorized Linear Translation Stages & Rotary Precision Positioning Stages for High Performance Automation & Motion Control | PI USA

Motion Controllers for Precision Positioning and Automation

Feb. 13, 2025
PI manufactures a range of precision motion controllers and drivers for positioning systems, including stepper motors, brushless motors, and servo motors.

Voice your opinion!

To join the conversation, and become an exclusive member of Laser Focus World, create an account today!